fourthirtysix
05-09-2004, 07:02 PM
I have been running a HD install on knoppix 3.3 for some time now and it works great. I have two SATA hard drives in the machine, and after I boot I have to run "hdparm -X66 -d1 /dev/hdg" in order to get the hard drives to work. In the past when I ran knoppix 3.3 from disk it recognized them automatically.
knoppix 3.4 won't boot at all with the 2.6 kernel! If I boot into "linux26" it will freeze / hang / lockup on the line "Probing SCSI... a100u2w.o"
if I boot with the "linux26 noscsi" option it writes "scanning for hard disk partitions and creating /etc/fstab" and then it starts repeating "disabling irq #18" over and over and over
I saw one post that said to disable plug n play BIOS, so i wnt into my BIOS and it doesnt have that option, but I did change it to not automatically do the plug n play IRQ thing automatically. Now it does Manual and still boots fine in 3.3
I have tried a huge variety of configurations using both linux24 and linux26 with the noscsi, nodma, noapic and acpi=off with little success.
I can boot successfully with "linux24 noscsi nodma"
However I am trying to boot with linux26 so I can do an HD install. I've tried linux26 with most of the options I list above with no success. The boot config of "linux26 noscsi nodma" will hang on the line "Accessing KNOPPIX CDROM on /dev/scd0.."
Can anyone help? Thank you!
knoppix 3.4 won't boot at all with the 2.6 kernel! If I boot into "linux26" it will freeze / hang / lockup on the line "Probing SCSI... a100u2w.o"
if I boot with the "linux26 noscsi" option it writes "scanning for hard disk partitions and creating /etc/fstab" and then it starts repeating "disabling irq #18" over and over and over
I saw one post that said to disable plug n play BIOS, so i wnt into my BIOS and it doesnt have that option, but I did change it to not automatically do the plug n play IRQ thing automatically. Now it does Manual and still boots fine in 3.3
I have tried a huge variety of configurations using both linux24 and linux26 with the noscsi, nodma, noapic and acpi=off with little success.
I can boot successfully with "linux24 noscsi nodma"
However I am trying to boot with linux26 so I can do an HD install. I've tried linux26 with most of the options I list above with no success. The boot config of "linux26 noscsi nodma" will hang on the line "Accessing KNOPPIX CDROM on /dev/scd0.."
Can anyone help? Thank you!