tsitras
05-14-2004, 01:32 PM
How to setup scanner in knoppix 3.3 hard disk install?
my scanner is a usb 'Mustek 1200 UB plus'
according to sane's website it is supported. the question now is how do i set it up?
tsitras
05-16-2004, 07:23 AM
could someone tell me how to setup the scanner? here is the output as root. as you can see the command 'sane-find-scanner' found the scanner 'found USB scanner (vendor=0x05d8, product=0x4002, chip=GT-6801?) at libusb:002:002'. ok now what do i do to set it up in my system?
root@amd:~# scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
root@amd:~# sane-find-scanner
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x05d8, product=0x4002, chip=GT-6801?) at libusb:002:002
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
root@amd:~#
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.