Miku
05-16-2004, 02:41 AM
Hi,
I have been masochistically attempting to get my lucent winmodem working with a HD install of Knoppix 3.3/4 (I believe it is a prerelease version of 3.4, more similar to 3.3 than anything else).
I have read funkea's advice in the thread: http://www.knoppix.net/forum/viewtopic.php?t=2050 but am still having problems.
I have done the following:
1) Downloaded and unzipped ltmodem-8.26a9.tar.gz into /tmp
2) Run ./build_module, then recompiled the source using gcc-2.95 when I got complaints about the gcc version.
3) Performed the commands:
mknod /dev/ttyLT0 c 62 64
chmod a+rw /dev/ttyLT0
ln -sf /dev/ttyLT0 /dev/modem
insmod -f lt_modem.o
insmod -f lt_serial.o
Everything seems to work OK, and when I run KPPP and attempt to connect the log window even displays the correct commands and responses to/from the modem: ie: "ATZ / OK" etc.
However, after the actual dial attempt (ie "ATDT12345678"), it always comes back with a NO DIALTONE response, and there is no evidence that the modem was used at all.
So, questions:
1) Are the responses from the modem script generated by the modem itself, or the drivers that I installed? (in which case there is no evidence that the modem has been detected or used at all).
2) How do I get it to work? :D
(Supporting info - scanmodem provided the following output:)
11c1:048c PCI bus PCI_ID with vendor component: 11c1
11c1:044c and Subsystem PCI_ID with vendor: 11c1
Thanks for any help.
I have been masochistically attempting to get my lucent winmodem working with a HD install of Knoppix 3.3/4 (I believe it is a prerelease version of 3.4, more similar to 3.3 than anything else).
I have read funkea's advice in the thread: http://www.knoppix.net/forum/viewtopic.php?t=2050 but am still having problems.
I have done the following:
1) Downloaded and unzipped ltmodem-8.26a9.tar.gz into /tmp
2) Run ./build_module, then recompiled the source using gcc-2.95 when I got complaints about the gcc version.
3) Performed the commands:
mknod /dev/ttyLT0 c 62 64
chmod a+rw /dev/ttyLT0
ln -sf /dev/ttyLT0 /dev/modem
insmod -f lt_modem.o
insmod -f lt_serial.o
Everything seems to work OK, and when I run KPPP and attempt to connect the log window even displays the correct commands and responses to/from the modem: ie: "ATZ / OK" etc.
However, after the actual dial attempt (ie "ATDT12345678"), it always comes back with a NO DIALTONE response, and there is no evidence that the modem was used at all.
So, questions:
1) Are the responses from the modem script generated by the modem itself, or the drivers that I installed? (in which case there is no evidence that the modem has been detected or used at all).
2) How do I get it to work? :D
(Supporting info - scanmodem provided the following output:)
11c1:048c PCI bus PCI_ID with vendor component: 11c1
11c1:044c and Subsystem PCI_ID with vendor: 11c1
Thanks for any help.