chestnut
05-27-2004, 01:03 AM
Hello
I have sucessfully installed knoppix 3.4 to hard-drive, using kernel 2.6.5
Everything seems to work fine (even better than my Slackware install!) but..
I cannot get Xine to run. The program just closes itself down. I ran it from a terminal, and the folowing message was displayed:
XiTK received
SIGSEGV signal, RIP.
Aborted
Any ideas??
Thank you
I have sucessfully installed knoppix 3.4 to hard-drive, using kernel 2.6.5
Everything seems to work fine (even better than my Slackware install!) but..
I cannot get Xine to run. The program just closes itself down. I ran it from a terminal, and the folowing message was displayed:
XiTK received
SIGSEGV signal, RIP.
Aborted
Any ideas??
Thank you