PDA

View Full Version : Emachines 6809


l00ph0le
09-18-2004, 02:31 AM
quick question, i just performed a hd install on my emachines 6809. However, my pcmcia is detected, however, any cards i have in the drive do not function.. Can anyone help me troubleshoot this problem?
l00ph0le
09-18-2004, 02:34 AM
BTW i am using knoppix26 with no cheatcodes or arguements to the kernel. If anyone can help me with getting the sound working that would be greats as well
l00ph0le
09-18-2004, 02:35 AM
figured i would post an update.. during boot, the cardmgr service starts and seems to be working...but no dice on my network card...which is a dell truemobile 1150 which i used to use under linux on my old laptop.
firebyrd10
09-18-2004, 02:52 AM
What type of sound card is it. Also, did you boot with the card in or out?

Try the opposite of what you've been doing.
l00ph0le
09-18-2004, 04:15 AM
its a laptop with an integrated sound card.

I think the sound may just be an issues of compiling the proper sound module into the kernel. The pcmcia issue is another thing all together
l00ph0le
09-18-2004, 07:15 AM
Ok, i have an update...
The cardmgr service works in kernel 2.4 with knoppix.
But my touch pad and or my keyboard will not work either.

What is the difference between 2.6 kernel and 2.4 kernel?
what could i do to enable my equipment so i have a working laptop?
l00ph0le
09-18-2004, 10:36 PM
update...

under 2.6 kernel i have gotten my cardbus to work properly.
There was a irq conflict with another system device. So in my /etc/pcmcia i excluded that irq and pcmcia grabbed another one.

Now if anyone can help me patch my orinoco drivers to enable monitor mode in 2.6.7 i would appreciate it.
l00ph0le
09-21-2004, 11:17 PM
Well, I sucessfully, patched my orinioco drivers and am now in monitor mode. Apparently, I was missing a sym link to asm. I now have a fully functional basic knoppix box...

Now to figure out some powersaving features.
artamangr
10-28-2004, 11:00 PM
update...

under 2.6 kernel i have gotten my cardbus to work properly.
There was a irq conflict with another system device. So in my /etc/pcmcia i excluded that irq and pcmcia grabbed another one.

Now if anyone can help me patch my orinoco drivers to enable monitor mode in 2.6.7 i would appreciate it.

Hi,
i also have a problem with my pcmcia wireless card using kernel 2.6
it works properly with the 2.4 kernel (by using " pump -i ath0") but not with 2.6
i am using a PMI installation of knoppix 3.7
can there be a solution for my case?