Uwe Brauer
10-14-2004, 06:50 PM
Hello
After having installed Knoppix 3.3 on my Laptop, I tried to connect
a cordless Logitech mouse, via the USB port. However it is not
detected my the Xserver. When I boot from the CD again, it is detected,
but of course I don't want to redo the installation. I could try to
edit the X86Config file, but I remember from my earlie SuSe days, that
there was a GUI (XF86Setup or something like this) which allow
me a configuration without editing the XF86Config file.
is there anything like this in Knoppix?
I looked for it but did not succeed.
thanks
Uwe Brauer
After having installed Knoppix 3.3 on my Laptop, I tried to connect
a cordless Logitech mouse, via the USB port. However it is not
detected my the Xserver. When I boot from the CD again, it is detected,
but of course I don't want to redo the installation. I could try to
edit the X86Config file, but I remember from my earlie SuSe days, that
there was a GUI (XF86Setup or something like this) which allow
me a configuration without editing the XF86Config file.
is there anything like this in Knoppix?
I looked for it but did not succeed.
thanks
Uwe Brauer