mike85gn
11-11-2004, 09:10 PM
I'm using a Dell Latitude D300 which works fine with Knoppix 3.3, under 3.6 when the boot screen comes up it says the following:
*****
Welcome to the KNOPPIX live Linux-on-CD!
Scanning for USB/Firewire devices... Done.
Enabling DMA accelseration for: hda [IBM-DADA-26480]
Enabling DMA accelseration for: hdc [TOSHIBA CD-ROM XM-1802B]
Looking for CD-ROM in: /dev/scd0 <flashing cursor>
*****
And that's where it hangs. I'm thinking about trying it without DMA acceleration, is there a command I can use at boot to disable DMA acceleration on hdc? Or could there be another problem? I'd like to install-to-HD, if this is the problem, how do I make the change permanent?
*****
Welcome to the KNOPPIX live Linux-on-CD!
Scanning for USB/Firewire devices... Done.
Enabling DMA accelseration for: hda [IBM-DADA-26480]
Enabling DMA accelseration for: hdc [TOSHIBA CD-ROM XM-1802B]
Looking for CD-ROM in: /dev/scd0 <flashing cursor>
*****
And that's where it hangs. I'm thinking about trying it without DMA acceleration, is there a command I can use at boot to disable DMA acceleration on hdc? Or could there be another problem? I'd like to install-to-HD, if this is the problem, how do I make the change permanent?