wolfgangbeyer
01-04-2005, 09:45 AM
I am using Knoppix 3.4 to save and restore my Windows XP partition (NTFS) with partimage. After doing this several times without any problems, there is suddenly the problem that after entering all parameters and starting, partimage does not start saving the partition, but displays "0%" for minutes. What can be the reason? "cat /proc/partitions" displays all partitions correctly. I also can save a VFAT partition without problems. I think that too much file fragmentation can not be the problem, because according to the partimage homepage, in this case an error message should occur. The partition to save is 15GB NTFS with about 5GB data and the image should be saved to a large VFAT partition on the same 160GB drive. I chose splitting of image to files of the size 2GB and last time I created this way successfully an image consisting of 2 files smaller than this limit. Unfortunately I don’t know much about Linux.
The only thing that has changed after the last successful image creation is an update of the following 2 BIOS components:
ASUS A7V600 ACPI 1006 - to version 1008
Serial ATA RAID BIOS Setting Utility 2.01 - to version 2.31
Can this be a problem for Knoppix 3.4 or partimage? Is it a good idea to try a newer Knoppix version? After rebooting Windows XP I see a file created by partimage at the correct path but with size zero.
The only thing that has changed after the last successful image creation is an update of the following 2 BIOS components:
ASUS A7V600 ACPI 1006 - to version 1008
Serial ATA RAID BIOS Setting Utility 2.01 - to version 2.31
Can this be a problem for Knoppix 3.4 or partimage? Is it a good idea to try a newer Knoppix version? After rebooting Windows XP I see a file created by partimage at the correct path but with size zero.