honigbaer
01-15-2005, 09:33 AM
Thanks to Knoppix, I became re-motivated to experiment with Linux since I gave up early attempts years ago.
Meanwhile I installed Asterisk a.s.o. and found that Knoppix is a perfect environment for this, especially one
is a Linux beginner :wink:
Today, I have one itching question and hope some of the experts out here could solve this:
- during installation, found hardware was written into /etc/modules.
Switching the hdd from one PC to the other therefore results in problems.
Refering to /etc/modules is nice in terms of speeding up the bootup process, but
- how could I switch back to "autoconfigure" like the CD does, so I am more flexible?
or
alternatively, how could I force the autoconfig thru a lilo append command, so if you just switched
to a new PC, I would run autoconfig once and have the modules.conf rewritten?
Thanks for your suggestions.
Rob
Meanwhile I installed Asterisk a.s.o. and found that Knoppix is a perfect environment for this, especially one
is a Linux beginner :wink:
Today, I have one itching question and hope some of the experts out here could solve this:
- during installation, found hardware was written into /etc/modules.
Switching the hdd from one PC to the other therefore results in problems.
Refering to /etc/modules is nice in terms of speeding up the bootup process, but
- how could I switch back to "autoconfigure" like the CD does, so I am more flexible?
or
alternatively, how could I force the autoconfig thru a lilo append command, so if you just switched
to a new PC, I would run autoconfig once and have the modules.conf rewritten?
Thanks for your suggestions.
Rob