View Full Version : File transfert with PLIP
little sumo
04-04-2003, 10:46 AM
As i use Knoppix as a rescue cd for various pc's, i tried to transfert files with a parallel cable.
So ,i set up a plip connection betwenn 2 pc's, they could ping each other, but i would like to transfer files with scp or something like (better with a GUI)
Thanks
Dave_Bechtel
04-05-2003, 01:49 AM
--There is a FAQ about setting up Knoppix CD as FTP server:
http://sourceforge.net/docman/display_doc.php?docid=15637&group_id=70773
--Here also is my info:
http://www.knoppix.net/forum/viewtopic.php?t=362
As i use Knoppix as a rescue cd for various pc's, i tried to transfert files with a parallel cable.
So ,i set up a plip connection betwenn 2 pc's, they could ping each other, but i would like to transfer files with scp or something like (better with a GUI)
Thanks
little sumo
04-05-2003, 01:55 PM
Thanks for your reply, but my ftp settings seem to be ok: when i try a ftp seesion with eth0, there is no problem.
Is there a config where i should say ftp, to lesson on plip0 instead of eth0?
Regards.
Dave_Bechtel
04-06-2003, 12:01 AM
--Hmm... Sounds like a routing issue to me, and route commands are beyond my ken.
Thanks for your reply, but my ftp settings seem to be ok: when i try a ftp seesion with eth0, there is no problem.
Is there a config where i should say ftp, to lesson on plip0 instead of eth0?
Regards.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.