Kowalsky
02-23-2005, 11:48 PM
Hi
I am having problems to convince Knoppix 3.7 to detect an existing SATA Raid 1 System.
The mainboard is a GA-8IPXDR E7500. 2 IDE drives: hda is ok, hdb belongs to /dev/ataraid/d0
2 SCSI DVD Drives.
The 2 SATA Drives are connected to the controller and are shown as /dev/hde and /dev/hdi, but
afair its kinda forbidden to directly access /dev/hde for writing.
How can I access this RAID 1 (normally /dev/sda)?
Which module/driver does Knoppix use for the Highpoint raidcontroller?
What I have seen the module hpt374 isnt in /lib/modules/....
(Does it make sense to compile the highpoint opensource drivers somehow
into knoppix - if possible?)
Any hint or tip would be really great
greetings
b
I am having problems to convince Knoppix 3.7 to detect an existing SATA Raid 1 System.
The mainboard is a GA-8IPXDR E7500. 2 IDE drives: hda is ok, hdb belongs to /dev/ataraid/d0
2 SCSI DVD Drives.
The 2 SATA Drives are connected to the controller and are shown as /dev/hde and /dev/hdi, but
afair its kinda forbidden to directly access /dev/hde for writing.
How can I access this RAID 1 (normally /dev/sda)?
Which module/driver does Knoppix use for the Highpoint raidcontroller?
What I have seen the module hpt374 isnt in /lib/modules/....
(Does it make sense to compile the highpoint opensource drivers somehow
into knoppix - if possible?)
Any hint or tip would be really great
greetings
b