GreyOwl
03-31-2005, 10:18 PM
Hi, Just booted Knoppix on a Thinkpad, ran 'LSPCI" to see if there is a modem detected,, there is.,,, so I need to know how to associate what I see in the lspci list as modem to a device such as /dev/modem. Below is the output of LSPCI that relates to my modem:
0000:02:02.0 Communication controller: Lucent Microelectronics WinModem 56k (rev 01)
Subsystem: AMBIT Microsystem Corp. IBM ThinkPad T23 (2647-4MG)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 (63000ns min, 3500ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at c0201000 (32-bit, non-prefetchable) [size=256]
Region 1: I/O ports at 6440 [size=8]
Region 2: I/O ports at 6000 [size=256]
Capabilities: <available only to root>
Another question: Do I need to install Knoppix on a hard drive to save configuation files? (I have a mountable memory key)
Thanks
0000:02:02.0 Communication controller: Lucent Microelectronics WinModem 56k (rev 01)
Subsystem: AMBIT Microsystem Corp. IBM ThinkPad T23 (2647-4MG)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 (63000ns min, 3500ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at c0201000 (32-bit, non-prefetchable) [size=256]
Region 1: I/O ports at 6440 [size=8]
Region 2: I/O ports at 6000 [size=256]
Capabilities: <available only to root>
Another question: Do I need to install Knoppix on a hard drive to save configuation files? (I have a mountable memory key)
Thanks