userwaldo
05-11-2005, 06:06 PM
i can't figure out how to pass parameters to a module a boot time.
the resaon i need to do this is that my e100 networking card is not coming at full speed and its really slow.
The paremater i need to pass to the e100 boot module is:
e100_speed_duplex=4
http://www.intel.com/support/network/adapter/1000/linux/e100.htm
I tried to rmmod my the e100 module and reload it with this pararmeter, but I couldn't reload it. I kept saying the that device or module was in use.
Can anyone help me figure out how to pass this parameter so that I can use my nic card at full speed?
the resaon i need to do this is that my e100 networking card is not coming at full speed and its really slow.
The paremater i need to pass to the e100 boot module is:
e100_speed_duplex=4
http://www.intel.com/support/network/adapter/1000/linux/e100.htm
I tried to rmmod my the e100 module and reload it with this pararmeter, but I couldn't reload it. I kept saying the that device or module was in use.
Can anyone help me figure out how to pass this parameter so that I can use my nic card at full speed?