masticate
06-14-2005, 08:45 AM
i am running knoppix 3.7 on two boxes and i have the same issue
i have two network interfaces eth0 and eth1
eth1 is the usb modem to internet
eth0 is network card to local network
every time i boot up i watch the screen info fly by and i can see the network interfaces being brought up and then back grounding?
when i log in and ifconfig all the interfaces are up and running (even control centre agrees) but if i ping a web address nothing happens
i have to go to netcardconfig and re set the eth1 interface (this often causes eth0 to fall out of bed so i have to restart that again)
i run a web server and this is a real pain in the but
can someone help
i am fairly ok with command line work if needed
m
i have two network interfaces eth0 and eth1
eth1 is the usb modem to internet
eth0 is network card to local network
every time i boot up i watch the screen info fly by and i can see the network interfaces being brought up and then back grounding?
when i log in and ifconfig all the interfaces are up and running (even control centre agrees) but if i ping a web address nothing happens
i have to go to netcardconfig and re set the eth1 interface (this often causes eth0 to fall out of bed so i have to restart that again)
i run a web server and this is a real pain in the but
can someone help
i am fairly ok with command line work if needed
m