Support of "3DLabs Oxygen GVX1 Pro"

[guyr]

Hi,

I get a garbage screen (X) with knoppix 3.8.2. with my
graphics card "3DLabs Oxygen GVX1 Pro"

I only need to manually replace "vesa" driver in Section "Device"
with "glint" and restart xsession. And now all is fine :-)

Perhaps somebody can fix the default behavior for a future release ?

Thanks.

Guyr

Extract of lspci -v :

0000:01:00.0 Co-processor: 3DLabs: Unknown device 000e (rev 01)
Subsystem: 3DLabs: Unknown device 0139
Flags: bus master, 66MHz, medium devsel, latency 64, IRQ 11
Memory at fe9c0000 (32-bit, non-prefetchable) [size=128K]
Capabilities: [40] AGP version 1.0

0000:01:00.1 VGA compatible controller: 3DLabs GLint R4 rev A (rev 01) (prog-if 00 [VGA])
Subsystem: 3DLabs: Unknown device 0139
Flags: 66MHz, medium devsel, IRQ 11
Memory at fe9e0000 (32-bit, non-prefetchable) [size=128K]
Memory at e8000000 (32-bit, non-prefetchable) [size=128M]
Memory at f0000000 (32-bit, non-prefetchable) [size=128M]
Expansion ROM at fea00000 [disabled] [size=64K]
Capabilities: [4c] Power Management version 1