srfpala
11-27-2005, 04:43 PM
How does one begin to determine which parameters to include in the boot process when the normal boot fails and only a failsafe boot works?
Also any clues as to why the internet is not accessible ?
BR
Bob
mmaki
11-27-2005, 11:07 PM
Try to determine where it fails during normal boot (networking, usb, scsi etc.) then use the cheat codes (http://www.knoppix.net/wiki/Cheat_Codes) to eliminate that piece of hardware.
In failsafe you can try to bring up your network with
# ifconfig eth0 up
and if that works,
# pump -i eth0
Good Luck!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.