raesene
02-26-2006, 06:01 PM
Hi,
I've just installed KNOPPIX 4.02 onto a USB hard disk, following the instructions on the wiki http://www.knoppix.net/wiki/USB_Based_FAQ .
What I'm looking to do now, but can't find out how to, is to change the setup to be read-write so that I can install additional packages to the USB disk.
If anyone can point me in the right direction, it would be much appreciated
Thanks
Rory
I've just installed KNOPPIX 4.02 onto a USB hard disk, following the instructions on the wiki http://www.knoppix.net/wiki/USB_Based_FAQ .
What I'm looking to do now, but can't find out how to, is to change the setup to be read-write so that I can install additional packages to the USB disk.
If anyone can point me in the right direction, it would be much appreciated
Thanks
Rory