pigspigs76
04-06-2006, 11:44 PM
ok so heres what i am doing:
1. Load up Linux from boot disk
2. Go to konsole
3. Typed the fallowing in order:
a. ifconfig eth0 up
b. iwconfig eth0 mode monitor --> when i did this it said:
"Error for wireless reqiest "set mode" (8B06): set failed on device eth0 ; Operation not supported
c. (after ignoring that) i opend "Aidrodump (traffic recorder)"
d. typed in the aidrodumb "airodump eth0 tocrack" --> when i did this it said:
"unsupported hardware link type 1 expected ARPHRD_IEEE80211 or ARPHRD_IEEE80211_PRISM did you put your card in monitor mode"
e. Well no i obviously did not put my card in monitor mode as a result of step b!!!!! not allowing for it to go into monitor mode!!!!!!!!!
4. Got angry and went back to windows in defeat...
So anyways dose anybody know why my wireless card wouldent go into monitor mode???
Is there a driver i need to download?
If so were do i get it and how do i install it (dose it have to be loaded up from a memory stick?)
Heres my setup:
Presario R3000 (spescificly: Compaq Presario R3060CA)
Broadcom 802.11b/g WLAN
Do you need any other information???
All help is appreciated!!!!
Thank you, pigs
1. Load up Linux from boot disk
2. Go to konsole
3. Typed the fallowing in order:
a. ifconfig eth0 up
b. iwconfig eth0 mode monitor --> when i did this it said:
"Error for wireless reqiest "set mode" (8B06): set failed on device eth0 ; Operation not supported
c. (after ignoring that) i opend "Aidrodump (traffic recorder)"
d. typed in the aidrodumb "airodump eth0 tocrack" --> when i did this it said:
"unsupported hardware link type 1 expected ARPHRD_IEEE80211 or ARPHRD_IEEE80211_PRISM did you put your card in monitor mode"
e. Well no i obviously did not put my card in monitor mode as a result of step b!!!!! not allowing for it to go into monitor mode!!!!!!!!!
4. Got angry and went back to windows in defeat...
So anyways dose anybody know why my wireless card wouldent go into monitor mode???
Is there a driver i need to download?
If so were do i get it and how do i install it (dose it have to be loaded up from a memory stick?)
Heres my setup:
Presario R3000 (spescificly: Compaq Presario R3060CA)
Broadcom 802.11b/g WLAN
Do you need any other information???
All help is appreciated!!!!
Thank you, pigs