PDA

View Full Version : Wireless - dmesg and iwconfig



wifiabc
06-22-2006, 01:27 PM
The following are the dmesg and iwconfig info I got using knoppix 4.0.2 on my laptop. Does this mean that my wireless interface has been detected by knoppix and should work?

dmesg:

eth1: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
eth1: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
eth1: mac 7.8 phy 4.5 radio 5.6
eth1: 802.11 address: 00:16:de:5c:db:00
eth1: Use hw queue 0 for WME_AC_BE traffic
eth1: Use hw queue 1 for WME_AC_BK traffic
eth1: Use hw queue 2 for WME_AC_VI traffic
eth1: Use hw queue 3 for WME_AC_VO traffic
eth1: Atheros 5212: mem=0xb0100000, irq=21


iwconfig

eth1 IEEE 802.11g ESSID:""
Mode:Managed Frequency:2.462 GHz Access Point: 00:23:CF:58:48:B7
Bit Rate:1 Mb/s Tx-Power:50 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/94 Signal level=-95 dBm Noise level=-95 dBm
Rx invalid nwid:746 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

wifiabc
06-26-2006, 11:05 AM
Problem solved using GRML. Works right out of the box unlike Knoppix.