Sodman74
12-03-2006, 12:09 AM
Whenever i try to boot off of the Live CD, it starts booting, but then just under
Startomg idev hot-plug hardware detection....started.
"Autoconfiguring devices....
WARNING :Autodetection seems to hang, please check your computers BIOS settings.
Please check
udevd-event[3337]: wait_for_sysfs: waiting for '/sys/class/net/eth2/device/driver' failed
loadkeys: error while loading shared libraries: /lib/libcfont.so.0: cannot read file data: Input/output error
consolechars: error while loading shared libraries: /lib:libcfont.so.0: cannot read file data: input error."
Then it goes on to say:
AGP bridge detected.
Video is (yet) unknown card, using (vesa) Server
Monitor is SeC3645, H:28.0-96.0kHz, V:50.0-75.0Hz
Using Modes "1024x768" "800X600" "600X280"
Scanning for Harddisk partitions and creating /etc/fstab....Done
Using Swap partition /dev/hda5
Network Device eth0 detected, DHCP broadcasting for IP. (Backgrounding)
Network Device eth1 detected, DHCP broadcasting for IP. (Backgrounding)
Network Device eth2 detected, DHCP broadcasting for IP.
And then it just stops. Dosent even crash, but it just stays like that. I can still type stuff but all it does is bring me down a line when i hit Enter.
Any and all Help appreciated, thanks. Oh yeah and i wasen't sure if this belonged here or in the hardware/booting section, but since it's a laptop i did it here, but MOD's can feel free to move it.
Startomg idev hot-plug hardware detection....started.
"Autoconfiguring devices....
WARNING :Autodetection seems to hang, please check your computers BIOS settings.
Please check
udevd-event[3337]: wait_for_sysfs: waiting for '/sys/class/net/eth2/device/driver' failed
loadkeys: error while loading shared libraries: /lib/libcfont.so.0: cannot read file data: Input/output error
consolechars: error while loading shared libraries: /lib:libcfont.so.0: cannot read file data: input error."
Then it goes on to say:
AGP bridge detected.
Video is (yet) unknown card, using (vesa) Server
Monitor is SeC3645, H:28.0-96.0kHz, V:50.0-75.0Hz
Using Modes "1024x768" "800X600" "600X280"
Scanning for Harddisk partitions and creating /etc/fstab....Done
Using Swap partition /dev/hda5
Network Device eth0 detected, DHCP broadcasting for IP. (Backgrounding)
Network Device eth1 detected, DHCP broadcasting for IP. (Backgrounding)
Network Device eth2 detected, DHCP broadcasting for IP.
And then it just stops. Dosent even crash, but it just stays like that. I can still type stuff but all it does is bring me down a line when i hit Enter.
Any and all Help appreciated, thanks. Oh yeah and i wasen't sure if this belonged here or in the hardware/booting section, but since it's a laptop i did it here, but MOD's can feel free to move it.