evenso
07-14-2010, 07:53 AM
Greetings Knoppix Forums,
I am a fan of Knoppix.
Recently I installed 6.2.1 to a 4Gb pen drive.
It boots and runs flawlessly on my old Dell Pentium M's.
However it has a fatal issue with my newer Dell Turion 64 about 2 seconds into boot. I tried booting failsafe and without hardware detection to no avail.
Linux Kernel 2.6.32.6, 1895 MB RAM
CPU 0: AMD Turion 64 X2 Mobile Technology TL-60 @ 1994MHz, 512 KB Cache
Knoppix 6 found at: /dev/sda1
. . .
insmod: cannot insert ' /mnt-system/KNOPPIX/modules/cloop.ko': Invalid module format (-1): Exec format error
Could not mount /mnt-system/KNOPPIX/KNOPPIX. Starting debugging Shell . . .
sh: can't access tty; job control turned off(Guess that is an obvious enough message from sh.)
I have been using and tinkering with Debian for 5 or 6 years but I am not real techie so I am hopping for some pointers!
Regards,
Freeman
I am a fan of Knoppix.
Recently I installed 6.2.1 to a 4Gb pen drive.
It boots and runs flawlessly on my old Dell Pentium M's.
However it has a fatal issue with my newer Dell Turion 64 about 2 seconds into boot. I tried booting failsafe and without hardware detection to no avail.
Linux Kernel 2.6.32.6, 1895 MB RAM
CPU 0: AMD Turion 64 X2 Mobile Technology TL-60 @ 1994MHz, 512 KB Cache
Knoppix 6 found at: /dev/sda1
. . .
insmod: cannot insert ' /mnt-system/KNOPPIX/modules/cloop.ko': Invalid module format (-1): Exec format error
Could not mount /mnt-system/KNOPPIX/KNOPPIX. Starting debugging Shell . . .
sh: can't access tty; job control turned off(Guess that is an obvious enough message from sh.)
I have been using and tinkering with Debian for 5 or 6 years but I am not real techie so I am hopping for some pointers!
Regards,
Freeman