Eradicator
06-11-2003, 05:06 PM
After trying many things to get my print server on my SMC barricade to work I think I have it figured out. I need to add a LPD printer under CUPS with my IP address and lp as the qeue name.
I tried searching the forums but have not found a solution to what is below. I am using 3.2.
BUT now I have a new problem. I can not get my preferences saved. I tried saving them via the Knoppix tab but when I reboot and try "Knoppix myconfig=scan" (no quotes) they do not load. They seemed to work a few days ago....now it seems it can't find the file. Should I set up a persistent home? Would the "knoppix home=scan" command be used then?
Also if I want to specify the drive it should look to for these files and it always shows hda1 and hda5 can I write "Knoppix myconfig=dev/hda1" or is it "Knoppix myconfig=/mnt/hda1" as the pop up window states when I save my config?
And last, why don't I have hda1 and hda2??? it just skips to hda5....
Thanks again
I tried searching the forums but have not found a solution to what is below. I am using 3.2.
BUT now I have a new problem. I can not get my preferences saved. I tried saving them via the Knoppix tab but when I reboot and try "Knoppix myconfig=scan" (no quotes) they do not load. They seemed to work a few days ago....now it seems it can't find the file. Should I set up a persistent home? Would the "knoppix home=scan" command be used then?
Also if I want to specify the drive it should look to for these files and it always shows hda1 and hda5 can I write "Knoppix myconfig=dev/hda1" or is it "Knoppix myconfig=/mnt/hda1" as the pop up window states when I save my config?
And last, why don't I have hda1 and hda2??? it just skips to hda5....
Thanks again