manjo
06-30-2003, 08:22 PM
I installed knoppix 2.3 06-06 version, it recognized my PCI MA311 wireless card, but it couldint set up network connection. I have 2 laptop with orinico PCMCIA wire less cards and they work fine. My access point is RG1000 (lucent piece of sh** ), its AP and a gateway.
I noitced a few strange things, the driver that knoppix loads are the orinoco and orinoco_pci drivers for my MA311 PCI card! I was under the impression that these cards are prism II cards, so I tried to manually load the prism2_pci driver, but it fails saying ":no device"
Strangely I was messing with it and somehow my card started to make connection with the internet, but this luck went away once I rebooted the machine. Now I am back to square one.
The situation is such:
1. all drivers orinoco_XXX are loaded and it is marked as used., and p80211 is also loaded.
2. no prism_XXX drivers are loaded (this is confusing to me )
3. I used wlcardconfig to configure the card, the only parameters I used were SSID=3ab190 and KEY = s:ab190 (these happen to work for my PCMCIA cards on my laptop)
4. ifconfig eth0 up brings up the wireless interface, RX:0 TX:18000, its transmitting packets but receivein none.
5. I edited /etc/network/interfaces and added the entry for the wireless interface.
Should I modify something on my lousy Lucent router so that my PCI card will work, or have I missed something with the Wireless setup on my desktop?? I have downloaded the JAVA client for my RG1000 but have no clue what set up on it.
Any help is DEEPLY appriciated
I noitced a few strange things, the driver that knoppix loads are the orinoco and orinoco_pci drivers for my MA311 PCI card! I was under the impression that these cards are prism II cards, so I tried to manually load the prism2_pci driver, but it fails saying ":no device"
Strangely I was messing with it and somehow my card started to make connection with the internet, but this luck went away once I rebooted the machine. Now I am back to square one.
The situation is such:
1. all drivers orinoco_XXX are loaded and it is marked as used., and p80211 is also loaded.
2. no prism_XXX drivers are loaded (this is confusing to me )
3. I used wlcardconfig to configure the card, the only parameters I used were SSID=3ab190 and KEY = s:ab190 (these happen to work for my PCMCIA cards on my laptop)
4. ifconfig eth0 up brings up the wireless interface, RX:0 TX:18000, its transmitting packets but receivein none.
5. I edited /etc/network/interfaces and added the entry for the wireless interface.
Should I modify something on my lousy Lucent router so that my PCI card will work, or have I missed something with the Wireless setup on my desktop?? I have downloaded the JAVA client for my RG1000 but have no clue what set up on it.
Any help is DEEPLY appriciated