PDA

View Full Version : help! I play knoppix, before i cant boot


mulder
07-02-2003, 04:12 AM
:cry: Before try with knoppix (sucesful), i reboot my pc.

Now i canīt boot my PC, no signal in the monitor, no boot from floppy or cd.

Why? What i can do?

My PC is DELL pentium 4, ram 128mb, windows 2000.

P.D. Sorry by mi bad english
Stephen
07-02-2003, 04:50 AM
Try unpluging the power cord for a few minutes then plug it back in and boot.
Colonel Sanders
07-02-2003, 05:06 AM
Well, the good thing is your probbably didn't harm your hard-drive.

I'd bet reseting the CMOS should do the trick but that means cracking the case open(and voiding the warranty). Un-plugging the PC probbably won't do much good because there will be a battery back-up on the motherboard. Hmmm, I'll letyou decide.

L J
fingers99
07-03-2003, 01:10 AM
Try setting your bios to boot from the hard drive (or put the hard drive before the CD in the boot order).

Strange problem, though.....
eadz
07-03-2003, 03:19 AM
Dells always seem to have this problem, search the forums for more discussion. I think maybe there should be a warning for dell users.
Stephen
07-03-2003, 03:55 AM
I think maybe there should be a warning for dell users.

I couldn't agree more I don't know how many times I've seen a similar post.
mulder
07-03-2003, 04:02 PM
:D I unpluged the CPU for one day (before only put on-off the pc) and my pc it is alive again. This avoid open the cpu and remove the battery.

Take note all DELL users for Unplug the cpu.

Tanks all for your support!

P.D. Sorry again by my english.
rickenbacherus
07-03-2003, 08:33 PM
I'd bet reseting the CMOS should do the trick but that means cracking the case open(and voiding the warranty).

Hmmmmm- voided warranty just for opening the case? What kind of nonsense is that? No wonder I've never been onclined to buy a Dell. I have had older machines that needed the cord uplugged to reset properly too.
rdoma219
07-08-2003, 10:41 PM
:shock:
Ihad a similiar problem with my dell 4550, after I set the bios to boot from cd knoppix ran fine. But after I removed the cd and rebooted to windows my computer would not boot. Found that there was an error in the memory module. I had to reseat the memory and then windows booted fine. Just be wary when using knoppix on a dell.

And on a different note I tried to run knoppix on an older compaq and found that the monitor is not compatible with knoppix, a compaq specific problem I am told.