PDA

View Full Version : After completing install, drive will not boot



chrismckpk
09-01-2003, 07:03 PM
After running knx-hdinstall and installing on a newly made linux partition ex3 and a linux swapfile and using Lilo bootloader, my computer will not start loading linux as it boots up. The linux partition is set as the boot partition. I also have a windows 2000 installation on a partition of the same disk if that is causing problems. Any reasons why this would happen?

Henk Poley
09-01-2003, 09:23 PM
Uhm, it does boot Windows? You do you get the lilo boot display (some red box)? Have you installed Lilo in the MBR (default, "yes" in knx-hdinstall) or the Linux partition itself?