SUOrangeman
11-02-2003, 03:21 AM
After getting the appropriate modules (from Mandrake 9.2) for my Promise SATA150TX4, KNOPPIX now recognizes my Raptor hard drive. At the CD's boot prompt, I use:
knoppix modules-disk
After loading the three required module files from floppy, the Raptor is detected and I can access its partitions.
I've run the included installer scripts and everything seemed to complete without any problems. Unfortunately, I cannot boot the HD installation because the modules files needed to recognize the hard drive weren't added to the initrd.
How can I modify the post-install initrd to add the necessary module files? Per this thread (http://www.knoppix.net/forum/viewtopic.php?t=1328), can someone like Fabian help?
**KEEP IN MIND, if I have to recreate the entire initrd, what modules are already included so I don't forget to keep them in the initrd?
Thanks in advance.
-SUO
Older related posts:
http://www.knoppix.net/forum/viewtopic.php?t=5487
http://www.knoppix.net/forum/viewtopic.php?t=5551
knoppix modules-disk
After loading the three required module files from floppy, the Raptor is detected and I can access its partitions.
I've run the included installer scripts and everything seemed to complete without any problems. Unfortunately, I cannot boot the HD installation because the modules files needed to recognize the hard drive weren't added to the initrd.
How can I modify the post-install initrd to add the necessary module files? Per this thread (http://www.knoppix.net/forum/viewtopic.php?t=1328), can someone like Fabian help?
**KEEP IN MIND, if I have to recreate the entire initrd, what modules are already included so I don't forget to keep them in the initrd?
Thanks in advance.
-SUO
Older related posts:
http://www.knoppix.net/forum/viewtopic.php?t=5487
http://www.knoppix.net/forum/viewtopic.php?t=5551