Artemisio
11-23-2003, 12:26 PM
Hi,
I've just installed a WLAN-PCI-Card (Belkin F5D6001 V.2) in my Computer - and unluckily, it's not found by Knoppix (3.3 - 2003-11-19).
The Specs:
Belkin F5D6001 V.2
Chipset: ADMTek 8211
Driver: exists for Linux (on ADMTek-Site)
PCI-Info:
Vendor 1317h ADMtek
Device 8201h Unknown
Command 0007h (I/O Access, Memory Access, BusMaster)
Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timing)
Revision 11h, Header Type 00h, Bus Latency 20h
Self test 00h (Self test not supported)
Cache line size 32 Bytes (8 DWords)
PCI Class Network, type Other
Subsystem ID 32011113h Unknown
Subsystem Vendor 1113h Accton Technology Corp
Address 0 is an I/O Port : 0000D400h
System IRQ 12, INT# A
Expansion ROM of 128Kb decoded by this card
New Capabilities List Present:
Power Management Capability
Supports power state D1
Current Power State : D0 (Device operational, no power saving)
It would be great if the appropriate driver could be integrated in one of the next iso-images of Knoppix.
Sincerely
Artemisio
Useful Links:
http://www.admtek.com.tw/index/index/download.htm
http://www.admtek.com.tw/download/nic/adm8211/ADM8211_src_105.tar.gz
http://www.admtek.com.tw/download/NIC/adm8211/ADM8211%20Datasheet%20%201.1.pdf
I've just installed a WLAN-PCI-Card (Belkin F5D6001 V.2) in my Computer - and unluckily, it's not found by Knoppix (3.3 - 2003-11-19).
The Specs:
Belkin F5D6001 V.2
Chipset: ADMTek 8211
Driver: exists for Linux (on ADMTek-Site)
PCI-Info:
Vendor 1317h ADMtek
Device 8201h Unknown
Command 0007h (I/O Access, Memory Access, BusMaster)
Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timing)
Revision 11h, Header Type 00h, Bus Latency 20h
Self test 00h (Self test not supported)
Cache line size 32 Bytes (8 DWords)
PCI Class Network, type Other
Subsystem ID 32011113h Unknown
Subsystem Vendor 1113h Accton Technology Corp
Address 0 is an I/O Port : 0000D400h
System IRQ 12, INT# A
Expansion ROM of 128Kb decoded by this card
New Capabilities List Present:
Power Management Capability
Supports power state D1
Current Power State : D0 (Device operational, no power saving)
It would be great if the appropriate driver could be integrated in one of the next iso-images of Knoppix.
Sincerely
Artemisio
Useful Links:
http://www.admtek.com.tw/index/index/download.htm
http://www.admtek.com.tw/download/nic/adm8211/ADM8211_src_105.tar.gz
http://www.admtek.com.tw/download/NIC/adm8211/ADM8211%20Datasheet%20%201.1.pdf