PDA

View Full Version : USB Diamond Supramax modem non-detected..



nooben
12-16-2003, 02:12 AM
Hi there,
i have the usb diamond supramax modem and when im booting it says that (usb detected, hotplug enabled..-by the way i didnt understand how hotplug works..) and the led of the modem is off and the modem isnt in the hardware detection list.

I installed the acm module without argument (dont know if it needs..) and after that still it wasnt detecting it. I read the FAQ and also the incompatible hardware list but i didnt see that my modem is in (or even the chipset)

cat lspcia
00:00.0 Host bridge: VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] (rev 44)
Flags: bus master, medium devsel, latency 0
Memory at e8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0

00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP] (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: e0000000-e7ffffff
Capabilities: [80] Power Management version 2

00:07.0 ISA bridge: VIA Technologies, Inc. VT82C596 ISA [Mobile South] (rev 12)
Subsystem: VIA Technologies, Inc. VT82C596/A/B PCI to ISA Bridge
Flags: bus master, stepping, medium devsel, latency 0

00:07.1 IDE interface: VIA Technologies, Inc. VT82C586/B/686A/B PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
Flags: bus master, medium devsel, latency 64
I/O ports at e000 [size=16]

00:07.2 USB Controller: VIA Technologies, Inc. USB (rev 08) (prog-if 00 [UHCI])
Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
Flags: bus master, medium devsel, latency 64, IRQ 11
I/O ports at e400 [size=32]

00:07.3 Host bridge: VIA Technologies, Inc. VT82C596 Power Management (rev 20)
Flags: medium devsel

00:0a.0 Multimedia audio controller: Ensoniq ES1371 [AudioPCI-97] (rev 06)
Subsystem: Ensoniq Creative Sound Blaster AudioPCI64V, AudioPCI128
Flags: bus master, slow devsel, latency 64, IRQ 10
I/O ports at e800 [size=64]
Capabilities: [dc] Power Management version 1

01:00.0 VGA compatible controller: S3 Inc. 86c368 [Trio 3D/2X] (rev 02) (prog-if 00 [VGA])
Subsystem: S3 Inc. Trio3D/2X
Flags: bus master, medium devsel, latency 64
Memory at e0000000 (32-bit, non-prefetchable) [size=64M]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [dc] Power Management version 1
Capabilities: [80] AGP version 1.0



Any suggestions?

Thx for reading this ;)