wombat
02-10-2004, 12:00 PM
Hello,
I am trying to use Knoppix and when I'm booting from the CD it gets to this point and says"processor 0 is M11 3 x core/bus clock 200 MHz" and it will go no further and my computer is frozen,I have to unplug it from the wall to get it to shut down and then I manually open the cd-rom to remove the Knoppix CD and turn the computer back on.This is a eTower 266 ,Cyrix m11 CPU,2.1 GB HD.Also I ran on my other computer and runs fine but when you logout and hit return key after cd ejects it sits there and I had to do the three finger salute aand the 98SE loaded half way and the monitor screen went bkack so I reset manually and it booted normally.Any help would be appreciated,wombat
I am trying to use Knoppix and when I'm booting from the CD it gets to this point and says"processor 0 is M11 3 x core/bus clock 200 MHz" and it will go no further and my computer is frozen,I have to unplug it from the wall to get it to shut down and then I manually open the cd-rom to remove the Knoppix CD and turn the computer back on.This is a eTower 266 ,Cyrix m11 CPU,2.1 GB HD.Also I ran on my other computer and runs fine but when you logout and hit return key after cd ejects it sits there and I had to do the three finger salute aand the 98SE loaded half way and the monitor screen went bkack so I reset manually and it booted normally.Any help would be appreciated,wombat