pepesz
02-24-2004, 12:57 AM
Hi, I'm newbe in linux :(
When I'm starting knoppix from cd I got:
hdf: drive not ready for command
hdf: drive not ready for command
ide-scsi: hdd: unsupported command in request queue (0)
--------------//--------------------- 7 x
ldm_validate_partition_table(): Disk read failed
ide-scsi: hdd: unsupported command in request queue (0)
--------------//--------------------- 3 x
hdf: drive not ready for command
hdf: drive not ready for command
I found somewhere that starting linux with parameter:
boot: vmlinuz ide2=0xc800, 0xcc02 ide3=0xd000, 0xd402
should help. When I get after the above message the following ones:
pdcraid: Error reading superblock
pdcraid: Error reading superblock
hptraid: Error reading superblock
hptraid: Error reading superblock
hptraid: Error reading superblock
silraid: Error reading superblock
after that knoppix configures the system and starts, but without seeing the disks:(
The disks are connected to ultra 100 tx2 promise pci card
What should i do ? The tech. supp. of promise techn. send me info that there are no drivers required since support for that card should be build in the kernel
thanx in advance
Lukasz
When I'm starting knoppix from cd I got:
hdf: drive not ready for command
hdf: drive not ready for command
ide-scsi: hdd: unsupported command in request queue (0)
--------------//--------------------- 7 x
ldm_validate_partition_table(): Disk read failed
ide-scsi: hdd: unsupported command in request queue (0)
--------------//--------------------- 3 x
hdf: drive not ready for command
hdf: drive not ready for command
I found somewhere that starting linux with parameter:
boot: vmlinuz ide2=0xc800, 0xcc02 ide3=0xd000, 0xd402
should help. When I get after the above message the following ones:
pdcraid: Error reading superblock
pdcraid: Error reading superblock
hptraid: Error reading superblock
hptraid: Error reading superblock
hptraid: Error reading superblock
silraid: Error reading superblock
after that knoppix configures the system and starts, but without seeing the disks:(
The disks are connected to ultra 100 tx2 promise pci card
What should i do ? The tech. supp. of promise techn. send me info that there are no drivers required since support for that card should be build in the kernel
thanx in advance
Lukasz