latotasite
04-26-2004, 09:07 PM
Hi everybody!
I am sorry, but my English is very poor. The situation is:
1* - KNX-HD Install
2* - Everything is OK, but when asking DHCP or manual configuration, none works. The installation stops, and a CTRL+C shows the prompt.
I can not continue the installation. DHCP does nothing, manual conf. is not responding...... all I have is an incomplete installation with a prompt.
If I work from CD, during the configuration of the ETH0 says "backgrounding" or something like that. The desktop comes, and everything is OK, but network fails.
I have a W2K DHCP (a previous Debian installation had no problem) and a D-LINK DFE 538 TX PCI network card.
Any ideas?
Thanks a lot from Argentina!
Carlos
I am sorry, but my English is very poor. The situation is:
1* - KNX-HD Install
2* - Everything is OK, but when asking DHCP or manual configuration, none works. The installation stops, and a CTRL+C shows the prompt.
I can not continue the installation. DHCP does nothing, manual conf. is not responding...... all I have is an incomplete installation with a prompt.
If I work from CD, during the configuration of the ETH0 says "backgrounding" or something like that. The desktop comes, and everything is OK, but network fails.
I have a W2K DHCP (a previous Debian installation had no problem) and a D-LINK DFE 538 TX PCI network card.
Any ideas?
Thanks a lot from Argentina!
Carlos