wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
Printable View
wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
Pete,
Sounds good to me, only you might need a swap partition...
From what I know of Knoppix, your swap should be in the following calculation:
1 GB - total memory = SWAP partition
or
500 MB
( which ever is greater )
If, on the other hand, you had 1 GB of RAM, then you would not need a swap at all.
You might check the DOCS link at the top of the page, and find the "minimum requirements" FAQ ( frequently asked questions ) and see how you compare, but, I think you are ok on them, not sure on your processor though, you didn't provide that in your initial post...
Hope this helps,
Ms. Cuddles