How To boot without CD after Poor Man's Install

I have an harddrive with 1.2GB as hda1 formatted as fat32.
I followed the Poor Man's Install and everything is ok.
I created a persistent home as image, i save my config.
Everything is ok, and running with cheatcodes:
knoppix home=scan myconfig=scan fromhd=/dev/hda1
but i'd want to boot from HD and not from CD, but i don't know how to configure the grub or the lilo.
Help me, please.

These may give you some ideas.

http://www.knoppix.net/forum/viewtop...?p=52847#52847
http://www.knoppix.net/forum/viewtop...?p=59980#59980

jd

see this:http://www.knoppix.net/docs/index.ph...HDInstallHowTo
it has tips about installing a toHD system.
To summarize:
use lilo. I'm assuming you have only one partition, hda1 (or hda1 plus a swap).
copy the directory /boot/isolinux from the cd to the hd.
you really only need the files /boot/isolinux/linux24, linux26, minirt24.gz & minirt26.gz.

Then edit /etc/lilo.conf add the following:

Code:

---

image=/mnt/hda1/boot/isolinux/linux24
 label="Knoppix3.4-24"
 append="lang=us fromhd=/dev/hda1 home=scan myconfig=scan apm=power-off"
 initrd=/mnt/hda1/boot/isolinux/minirt24.gz
 read-only

 image=/mnt/hda1/boot/isolinux/linux26
 label="Knoppix3.4-26"
 append="lang=us fromhd=/dev/hda1 home=scan myconfig=scan apm=power-off"
 initrd=/mnt/hda1/boot/isolinux/minirt26.gz
 read-only

---

If you have another o/s, add it too. a windows entry is usually

Code:

---

other=/dev/hda1
label="Windows"
table=/dev/hda

---

run lilo to install lilo to the mbr.

That's it, you should now be able to boot into your Knoppix.
If you are unable to edit /etc/lilo.conf because of the read only file system, copy it to /home/knoppix then run lilo with
lilo -c /home/knoppix/lilo.conf

Oops; sorry I think this should be:

Code:

---

image=/dev/hda1/boot/isolinux/linux24
and
 initrd=/dev/hda1/boot/isolinux/minirt24.gz

---

not

Code:

---

image=/mnt/hda1/boot/isolinux/linux24

 initrd=/mnt/hda1/boot/isolinux/minirt24.gz

---

Quote:

---

Originally Posted by CrashedAgain

Oops; sorry I think this should be:
...

---

Sorry but it's the other way around; eg the mnt entries are the correct ones. Note that hda1 needs to be mounted (eg on its default mount point /mnt/hda1) when running lilo. I advise to always run "lilo -v" and pay attention to the possible error messages.

Quote:

---

Originally Posted by baldyeti

Quote:

---

Originally Posted by CrashedAgain

Oops; sorry I think this should be:
...

---

Sorry but it's the other way around; eg the mnt entries are the correct ones. Note that hda1 needs to be mounted (eg on its default mount point /mnt/hda1) when running lilo. I advise to always run "lilo -v" and pay attention to the possible error messages.

---

Right. I thought of that also but haven't had time to correct myself yet.