-
Firewall Tool in 3.9
I am using the GUI firewall tool that is supplied in knoppix 3.9. I want to allow incoming access to ssh and an application server on port 62856. I've set the mode to expert even though I 'm not. When I start the firewall I can't connect on the ssh or application port. Do you know what I'm doing wrong? Note, I'm not using NAT and there is no firewall in front of of the PC. Below is the contents of /etc/sysconfig/firewall.iptables
Code:
# internal interfaces
iptables -A INPUT -i lo -j ACCEPT
iptables -A OUTPUT -o lo -j ACCEPT
# all outgoing
iptables -A OUTPUT -o eth0 -j ACCEPT
# SSH access
iptables -A INPUT -p tcp -i eth0 --dport 22 -j ACCEPT
# Application access
iptables -A INPUT -p tcp -i eth0 --dport 62856 -j ACCEPT
-
Ok, figured out the problem. After turning on the firewall I ran the command "iptables -L" to get a list of all the rules. I noticed that the rules I added in firewall.iptables were being appended after the DROP all rule. The solution is to insert the new rules before the DROP all rule. Just use "iptables -I" instead of "iptables -A"
So here it is.
Code:
# SSH access
iptables -I FROMINTERNET 3 -p tcp -m tcp --dport 22 -m state --state NEW -j ACCEPT
# Application access
iptables -I FROMINTERNET 4 -p tcp -m tcp --dport 62856 -m state --state NEW -j ACCEPT
Similar Threads
-
By Richard Kalp in forum General Support
Replies: 1
Last Post: 01-27-2008, 01:19 PM
-
By beerak in forum Hdd Install / Debian / Apt
Replies: 1
Last Post: 03-24-2006, 09:03 AM
-
By Albrecht Benz in forum German Forum
Replies: 3
Last Post: 02-23-2005, 09:38 AM
-
By lmsaga in forum Hdd Install / Debian / Apt
Replies: 0
Last Post: 04-25-2004, 11:12 PM
-
By FelixDzerzhinsky in forum Hdd Install / Debian / Apt
Replies: 5
Last Post: 01-27-2003, 07:02 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Samsung 16GB (2x8GB) DDR4 2400MHz PC4-19200 Desktop RAM Memory M378A1K43CB2-CRC
$19.95
Samsung 16GB 2Rx4 PC4-2133P DDR4-17000 1.2V RDIMM ECC Registered Server Memory
$16.29
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$13.25
TeamGroup 16GB PC4 2666 PC4 21300 DDR4 2666MHz 1.2V CL19 Desktop RAM Memory
$27.95
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 128GB 8x 16GB 2Rx4 PC4-19200R DDR4 2400 ECC REG RDIMM Server Memory RAM
$175.92