ahhhahah same problem here i u figure it out tell me!!!!
I am using auditor which is built on knoppix and I am having problems putting my MA401 into monitor mode.
here is what I use:
iwconfig wlan0 monitor mode
error message I get:
Error for wireless request "set mode" (8B06) :
SET failed on device wlan0 ; operation not supported.
ahhhahah same problem here i u figure it out tell me!!!!
there is a thread on this on linuxquestions.org
did it work for you?, if so what thread helped you?
Hello,
"su" to root and iwconfig eth* mode monitor should work for you.
So, in your case, at the command line "su" , then enter root password if any.
Then do "iwconfig wlan0 mode monitor" , note the correct syntax, and without colons.
Br,
MrBean
NetFu Firewall 1U, Intel CPU, 8 x Gigabit, SFP, w/ pfSense, Others, NEW OPTIONS
$509.58
NEW NetFu Firewall Mini, Intel CPU, 6 Port Gigabit, w/ pfSense, others
$336.00
Cisco ASA5525-FTD-K9 Security Appliance with FirePower Services
$1000.00
Fortinet Fortigate FG-61E | Firewall Network Security Appliance
$49.99
Fortinet FortiGate FG-40F Network Security Firewall
$100.00
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Ubiquiti Networks UniFi Security 1000Mbps Gigabit Gateway - White (USG)
$89.00
Fortinet Fortiwifi 60D FWF-60D Security Appliance Firewall Wifi VPN
$29.99
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$999.97
Fortinet FortiGate 60E & FortiAP 221E+ Network Security Firewall
$260.00