Hi,
I´m trying to run knoppix in an old PC (PIII 550, with a SIS 900 PCI Ethernet adapter), and i´m having problems to access the internet.
When i boot with the live CD it recognize and configure the card, but (i supose) with speed autodetection. The problem is that, at least in windows, that card only works fine with the manual selection of 10MBps fullduplex. Is that any way to manually choose the speed in knoppix?
Thanks
Paulo Sampaio
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
EX2300-24P Juniper 24-port 10/100/1000BASE-T PoE+ 4 x 1/10GbE SFP/SFP+ UNCLAIMED
$450.00
🍀 NEW SEALED Juniper Networks EX3400-48P 48-Port Gigabit PoE+ Switch LOT AVAIL
$999.99
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX2300-24P 24 Port Gigabit PoE 4 SFP 1/10G Network Switch
$115.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper Networks EX3400-48P 48x Gigabit PoE+ RJ45 2x 40Gb/s QSFP+ Switch
$166.24
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$41.21
Juniper ACX1100 8-Port GbE 4-SFP Universal Access Router w/Ears ACX1100-AC #73
$150.00
Juniper Networks EX3300-24P 24-Port PoE+ 4x SFP+ Network Switch TESTED
$79.99