I had re-installed Knoppix to HD after having a problem with the filesystem. All went o.k. except that I can't boot Linux anymore. It starts the boot process, regognizes disks, installs RAMDISK etc. Last message is
RAMDISK: Compressed image found at block 0
Then it freezes. When I boot from the floppy, it shows the same message but then goes on.
Since my Linux is on the second HD (hdb4), I assume that the configuration wrote the correct LILO in the MBR of hdb.
1. Does that seem to be a reasonable assumption?
2. If so, how do I get lilo to write the current config to the MBR of hda?
Cheers
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco SG110 8 Port Gigabit Ethernet Switch SG110D-08-BR
$39.00
Cisco Catalyst (WS-C3750V2-48PS-S) 48-Ports-Ports Rack-Mountable Switch Managed
$65.00
Cisco MS120-48FP - 52 Ports Fully Managed Ethernet Switch UNCLAIMED
$449.00
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$18.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$15.99
NETGEAR 5-Port Gigabit Ethernet Unmanaged Switch (GS305) - NEW IN BOX
$18.99
Cisco WS-C3750X-48T-S 48 Port 3750X Gigabit Switch - Same Day Shipping
$49.99
*NETGEAR PROSAFE (JGS524V2) 24-Port Gigabit Ethernet Switch *NO AC*
$29.99
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$89.97