I had re-installed Knoppix to HD after having a problem with the filesystem. All went o.k. except that I can't boot Linux anymore. It starts the boot process, regognizes disks, installs RAMDISK etc. Last message is
RAMDISK: Compressed image found at block 0
Then it freezes. When I boot from the floppy, it shows the same message but then goes on.
Since my Linux is on the second HD (hdb4), I assume that the configuration wrote the correct LILO in the MBR of hdb.
1. Does that seem to be a reasonable assumption?
2. If so, how do I get lilo to write the current config to the MBR of hda?
Cheers
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$42.00
Cisco Catalyst WS-C3650-24PS-L 24-Port Gigabit Ethernet Network Switch TESTED
$49.99
Loocam Gigabit PoE Switch 8 Port 96W 2 Uplink Port Unmanaged Ethernet Switch
$49.99
Dell PowerSwitch N2048P 48 Port Gigabit PoE Network Switch w/ Lifetime Warranty
$135.00
TRENDnet TEG (TEG-S80g) 8-Port Gigabit GREENnet External Switch Version V3.1R
$12.64
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Cisco Catalyst WS-C2960G-8TC-L Compact 8-Port Gigabit Ethernet Switch
$44.98
TP-Link TL-SG108PE 8-port Gigabit Easy Smart PoE+ Swith w/ 4-port PoE - Sealed
$49.50
Dell PowerConnect 6224 Rackmount 24-Port Gigabit Managed Ethernet Network Switch
$31.99
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97