Knoppix installed from CD only recognizes and works with my Xircom 10/100 ethernet card. But when I installed it to the hard drive, it fails to work. I'm new to all this, so it has been a frustrating few days.
The bootup process reports this:
1. Network check eth0
2. Network stop eth0
3. sbin/pump -r -i eth0
4. Operation failed
5. /sbin/ifconfig eth0 down
6. modprobe -r xirc2ps_cs
7. exiting
...open_sock (0) failed, etc
Once booted,
cardctl ident
correctly reports the Xircom card in the slot, so it seems the pcmcia slot is working.
I'd sure appreciate any help from here!
--Brent
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95