boot from cd, save the /etc/X11/XF86config-4 file, and compare it with your hd-install - XF86... -file.
Use diff or kdiff.
diff file1 file2 | less
replace the hd- with the cd-file.
I have installed knoppix by knx-hdinstall, but it doesnt work properly. After it enters init 5 level, my screen just start flickering. Is that a problem of resolution ?? How do I overcome this? I had also installed Knoppix with same CD but at that time everything was working fine. Are there any options I need to give while installing knoppix on harddisk
boot from cd, save the /etc/X11/XF86config-4 file, and compare it with your hd-install - XF86... -file.
Use diff or kdiff.
diff file1 file2 | less
replace the hd- with the cd-file.
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
lot of 10 Juniper EX-SFP-10GE-SR Compatible 10GBASE-SR SFP+ 850nm 300m DOM -J499
$209.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.10
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX4600-40F-AFI 24 SFP+/SFP Ports 4 QSFP+ Ports Dual AC Switch
$999.00
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00