-
Parallel port configuration for direct connection
Cannot configure properly my plip port. There isn't the device information on /proc/net/dev, so I must uso PPPoE to find the plip0 port. This way it's not so fair, and I think can't connect my two computers because there is no way to set other parameters as baud rate, ecc...
How can I do?
Thanks,
Blueagle
Similar Threads
-
By acanton in forum General Support
Replies: 0
Last Post: 05-24-2004, 01:48 AM
-
By KeTZer in forum Hardware & Booting
Replies: 0
Last Post: 05-13-2004, 01:47 PM
-
By KeTZer in forum General Support
Replies: 0
Last Post: 05-10-2004, 03:18 PM
-
By jdong in forum General Support
Replies: 1
Last Post: 08-06-2003, 03:11 AM
-
By tas in forum Hardware & Booting
Replies: 1
Last Post: 06-27-2003, 07:55 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
8 Ports Unmanaged Industrial Ethernet Switch Network Gigabit Ethernet Switch
$76.50
Cisco Meraki MS120-48LP 48 Port Blade Ethernet Switch UNCLAIMED
$349.98
Cisco SG110 8 Port Gigabit Ethernet Switch SG110D-08-UK
$39.00
InHand Networks 5/8 Port Industrial Unmanaged Fast Ethernet/Giga DIN-Rail Switch
$76.50
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
HP Aruba 2530-8G-PoE+ 8x PoE+ RJ45 2x SFP Gigabit Switch J9774A No AC Adapter
$37.99