Cannot configure properly my plip port. There isn't the device information on /proc/net/dev, so I must uso PPPoE to find the plip0 port. This way it's not so fair, and I think can't connect my two computers because there is no way to set other parameters as baud rate, ecc...
How can I do?
Thanks,
Blueagle
Atari A8 800xl 65xe 130xe XEGS Pico Kit Fully Assembled Multicart A8Picocart
$29.00
Atari 810 Floppy Disk Drive for Atari 8-bit Computer FOR PARTS As-Is
$20.00
Atari 1040ST - STFM - computer | Recapped PS and Floppy drive
$299.00
ATARI ST DIN13 TO VGA ADAPTOR LOW-MEDIUM/HIGH SWITCHABLE WITH AUDIO OUT
$19.66
Vintage Atari 820 Printer - Hard To Find
$200.00
Atari 1020 Printer w/Original Power Supply TESTED Works No Box, Manual or Ink
$69.99
Vtg Atari 1050 Floppy Disk Drive 5.25” For Parts Only Incomplete Untested
$50.00
Vintage ATARI 600XL Home Personal Computer Console UNTESTED
$100.00
A8PicoCart Kit Atari 130 65 XE 800 600 XL unocart clone multicart cartridge game
$19.95
Atari 2600 4 Switch Console in Box. See details.
$31.99