Hi, I just got Knoppix installed on my laptop (FMV-BIBLO Loox T9/80M) without much of trouble. However, I found two problems that did not occur when I run Knoppix from the CD.
Problems are:
1. I cannot use USB mouse
2. The sound does not work
When Knoppix booted from the CD, it actually detected my USB mouse with the following message: "USB found, managed by hotplug. (Re)Scanning ..... [001 002]" (not exact message)
But, Knoppix from the HDD does not do that. Instead, it only shows "USB found, managed by hotplug." and that is it.
For the sound card Knoppix from the CD detects it and load the module for it. However, I cannot see the same line at all when I boot from the HDD.
I installed using knoppix-installer with 'beginner' mode. I can use Linux, but I am not an expert on configuring and doing complicated things... I really appreciate a lot if you somebody help me out here.
Thank you!
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
HP/HPE ProLiant AMD Opteron X3216 APU 16 GB RAM MicroServer Gen 10 NO DRIVES
$299.99
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.99
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon
$846.19
HP ProLiant Xeon E3-1220L V2 2.30 GHz 16 GB RAM MicroServer Gen8 NO DRIVES
$199.99
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
Supermicro 5018A-FTN4 Rack Server - Black
$125.00
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00
2U 12 Bay SAS3 SuperMicro Server 6028U-TR4T+ W/ X10DRU-i+ Barebone 12 Caddy RAIL
$299.00