very interesting, but that's exactly I'm trying to figure myself....
If I can figure something, I'll tell you too...
I am trying to install Knoppix from live CD to Virtual PC, had not had any success. I boot with the CD in Virtual PC then I run the command KNX2HD, it goes in to install then stops and says HDD is read only can not write.
I am new to Linux, anyone have any ideas how can I install knoppix on Virtual PC.
Thanks
MasterCheef
very interesting, but that's exactly I'm trying to figure myself....
If I can figure something, I'll tell you too...
lol. ican not even boot it from cd . I need some help. ThanksOriginally Posted by Fenix*NBK*
I just installed knoppix on an MS Virtual PC 6 disk image. I had to convert the drive image to fixed size from dynamic expanding. Using the sudo knoppix-installer system, it seemed to work perfectly. Hope this helps someone.
Thanks for this feedback. Well could u explain a little more. I want to mount the knopix live cd in to virtual drive and then use that virtual drive with MS virtual pc . OR burn the knopix live cd in to cd and use it with virtual pc. is they a specile way of burning the image to allow it run in virutal pc ? looking forward to your reply.Originally Posted by macphlak
How I had Virtual PC 6 set:
New Virtual HD ready to install Linux on.
Memory settings set at 128+MB
Boot from CD Allowed.
I had:
One Knoppix CD burned with Roxio Toast from the most recent ISO in my internal CDROM
One Graphite iMac DV SE g3/500mhz running 10.3.5
What I did:
Booted the Linux ready virtual drive which started off the CD.
Typed in knoppix at boot
waited forever to get KDE to load (You don't need the Virtual additions (I didn't at least)
used the Konsole to run sudo knoppix-installer
used formatting software built in the software to make a root and swap partitions
followed the wizard's instructions (chose knoppix install instead of debian)
went to watch The Complete Works of William Shakespeare Abridged
came back and it was installed
You should just be able to click cd; (from the create vp wizard) then hit "capture iso" and select the iso from the cd rom, or better still wherever you have it on your computer; (now it's visible under "cd") then click file -- hit "ctrl alt del" and see it fire up, virtually, no installation necessary: about 2 minutes on my system.
MS user:free2click@yahoo.com
1. click cd -- hit "capture iso"
2. click file -- hit "ctrl alt del"
3. see it fire up!
Cisco SG200-26 26-Port Gigabit Network Smart Switch
$76.49
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Cisco 24-Port Managed Gigabit Switch WS-C3750G-24TS-S
$49.99
Cisco IE-3000-8TC Industrial Ethernet 8 Ports Managed Switch 1 Year Warranty
$114.00
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95