Hi. I installed Knoppix 3.3 on HDD. When I boot off HDD, startx won't work but it works when I boot from CD.
Hardware is Dell Latitude CPi, NeoMagic. At first, it just tried the SVGA so I made a change so that it would use NeoMagic(/etc/sysconfig/xserver)...shouldn't it do that automatically like on the CD?
I get lots of no symbols found for libGLcore.a and libspeedo.a and font render already registered at priority 0. Is that normal? I dont think this is the problem though.
Here is what is different in the logs.
Good:
(II) PCI: stages = 0x03, oldVal1 = 0x8000183c, mode1Res1 = 0x80000000
(II) Bus 1: bridge is at(0:3:0),(0,1,4), BCTRL: 0x0500()VGA_EN is cleared
(II) Bus 5: bridge is at(0:3:0),(0,1,4), BCTRL: 0x05c0()VGA_EN is cleared
Bad:
(II) PCI: stages = 0x03, oldVal1 = 0x00000000, mode1Res1 = 0x80000000
(II) PCI: 01:00:0 chip 1737,ab08 card 1737,ab08 rev 11 class 02,00,00 hdr 00
(II) Bus 1: bridge is at(0:3:0),(0,1,4), BCTRL: 0x05c0()VGA_EN is cleared
(II) Bus 5: bridge is at(0:3:0),(0,1,4), BCTRL: 0x05c0()VGA_EN is cleared
Seems like my startup is detecting different things. Any ideas?
ORICO 5 Bay Raid Enclosure USB3.0 SATA External Hard Drive Enclosure Up to 80TB
$115.59
Dell EMC 092GD6 Broadcom 9305-16i LSI Quad Port 4 Port SAS RAID Controller
$84.99
8 Bay Tool Less Tray Hot Swap 2.5" 3.5" SATA Non RAID Ext USB 3.0 Enclosure USED
$145.00
OWC Guardian Maximus Raid Enclosure SATA Hard Drive FireWire
$36.99
ASUS Hyper M.2 x16 Gen 4 RAID Card- Used Working
$32.95
Dell PERC H330 PCIe 3.0 x8 RAID Storage Controller 4Y5H1 High Profile
$17.99
Broadcom LSI 9400-16i Raid card SAS/SATA/NVME SFF-8643 SAS3416 PCIe 3.1 x8 HBA
$95.00
WD TB My Book Duo Desktop RAID External Hard Drive 0TB NO DRIVES
$42.00
ORICO 5 Bay Raid USB3.0 to SATA External Hard Drive Enclosure for 3.5'' HDD LOT
$134.39
Yottamaster 5 Bay RAID Hard Drive Enclosure Type-C B For 2.5" 3.5" SATA HDD SSDs
$139.99