Hmm, nobody knows how to compile kernel under knoppix????
I installed Knoppix on my hdd. I chose reiserfs. I need to recompile kernel in order to make it work with ALi 15x3 chipset and USB 2.0. After compilation and installation of the kernel it cannot boot because it cannot use reiserfs root partition. Is there any way to make properly working initrd on Knoppix?
Here is my kerenel compilation procedure:
1. su root
2. apt-get install kernel-source-2.4.20
3. cd /usr/src
4. tar --bzip2 -xvf kernel-source-2.4.20.tar.bz2
5. ln -s kernel-source-2.4.20 linux
6. patch -p0 < patches/alim15x3.patch
7. cd linux
8. patch -p1 < ../patches/usb-ehci-2.4.20-pre11.patch
9. make xconfig
10. make-kpkg clean
11. make-kpkg --append_to_version -crusoe --initrd --revision=01 \
kernel_image modules_image
12. cd ..
13. dpkg -i kernel-image*.deb
14. Adding new kernel entry to lilo.conf
15. lilo
16 Rebooting...
Hmm, nobody knows how to compile kernel under knoppix????
Sorry - ext3 works for me- -I don't need Reiser.
Just compile reiserfs support into the kernel, not as a module,
and don't use initrd. That's how I do things when I compile
my custom kernels under other distributions...
Oracle 7085209 LSI MegaRAID SAS 9361-8i 1GB Cache 12Gbps SAS/SATA PCIe RAID Card
$28.20
Cisco UCS LSI MegaRAID 9271CV-8I SAS2308 PCIe SAS Internal RAID Controller
$28.00
LSI 9305-16i SATA SAS 12Gbs RAID Controller PCIe 3.0 x8 IT-Mode 4* 8643 SATA
$229.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
LSI MegaRAID 9361-8i 12Gb PCIe 8-Port SAS/SATA RAID 1Gb w/BBU/CacheVault/License
$39.95
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$82.49
RAID Enclosure - 2 Disks - 3.5" or 2.5" RAOD 0, 1, JBOD - RAID Switch on Device
$46.65
NEW LSI MEGARAID SAS 9361-8i 12GB/s SAS + SATA RAID CONTROLLER CARD PCIe x8 3.0
$99.00