Hmm, nobody knows how to compile kernel under knoppix????
I installed Knoppix on my hdd. I chose reiserfs. I need to recompile kernel in order to make it work with ALi 15x3 chipset and USB 2.0. After compilation and installation of the kernel it cannot boot because it cannot use reiserfs root partition. Is there any way to make properly working initrd on Knoppix?
Here is my kerenel compilation procedure:
1. su root
2. apt-get install kernel-source-2.4.20
3. cd /usr/src
4. tar --bzip2 -xvf kernel-source-2.4.20.tar.bz2
5. ln -s kernel-source-2.4.20 linux
6. patch -p0 < patches/alim15x3.patch
7. cd linux
8. patch -p1 < ../patches/usb-ehci-2.4.20-pre11.patch
9. make xconfig
10. make-kpkg clean
11. make-kpkg --append_to_version -crusoe --initrd --revision=01 \
kernel_image modules_image
12. cd ..
13. dpkg -i kernel-image*.deb
14. Adding new kernel entry to lilo.conf
15. lilo
16 Rebooting...
Hmm, nobody knows how to compile kernel under knoppix????
Sorry - ext3 works for me- -I don't need Reiser.
Just compile reiserfs support into the kernel, not as a module,
and don't use initrd. That's how I do things when I compile
my custom kernels under other distributions...
HPGYT DELL 960GB SATA 6Gb/s 2.5in Internal SSD 0HPGYT MTFDDAK960TCB
$59.00
G5T03 Dell Intel DC S3700 Series 800GB SATA 6Gb/s 2.5" SSD 0G5T03 SSDSC2BA800G3E
$55.00
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
M.2 NVME SATA SSD Enclosure USB 3.2 Gen 2 10Gbps for M-Key or M+B Key SSD to 8TB
$40.86
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$14.99
Micron 5100 MAX 120GB SATA 6Gb/s 2.5" Internal SSD MTFDDAK120TCC Solid State
$9.99
Intel DC S3510 Series 120GB SSD 2.5" 6Gb/s SATA Solid State Drive SSDSC2BB120G6K
$9.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Fanxiang SSD 512GB 1TB 2TB 4TB 2.5'' SSD SATA III Internal Solid State Drive lot
$198.99
Fanxiang 256GB 512GB 1TB 2TB 4TB Internal SSD 2.5" SATA III 6GB/s for PC/MAC Lot
$188.09