Have you run netcardconfig ?
All,
After hdd installation with knoppix option, I can't get dynamic IP addr automatically on boot time. From the screen message, i see the interface is dynamically configurated (backgrounding). But the interface eth0 is not up then. Grep gives an process "pump -i eth0", but ifconfig eth0 gives nothing. I have to input 'pump' command manually to make eth0 up.
And the 'pump' output in knoppix-autoconfig is "operation failed".
Any hints?
Regards,
Have you run netcardconfig ?
no.
The problem dissappearrd after I re-install it.
But there is another question. Is hdd-install will re-configure XFree86 each time reboot? My mouse dosn't work in X. If I delete /etc/X11/XF86Config-4, then the mouse will work after I reboot. But If I don't delete it, it will not work even reboot.
Vintage Intel Personal PC CPU Collection in White Shadowbox Display
$200.00
VINTAGE SummaGraphics SummaMouse
$240.00
Vintage Sound Blaster 16 manual lot
$20.00
Vintage Tandy Radio Shack Pocket Computer PC-4 with 72pg manual and sleeve
$59.00
Vintage IBM 5150 5160 Personal Computer PC XT Drive cover Factory
$79.99
Z80 - NABU PC & Keyboard - Vintage New Old Stock (Retro 80's)
$139.99
Vintage Classic Apple Macintosh System Boot Install Disk Floppy/CD *Pick Version
$10.39
Vintage Black Microsoft intellimouse Optical USB Wheel Mouse 1.1/1.1a - EXC COND
$28.95
SEALED Vintage Western Digital Value Line Hard Drive 3.5-Inch Enhanced IDE 25 GB
$100.00
Vintage Computer Chip Gold White Ceramic Intel C1702A Static EPROM 2048-bit 1972
$95.00