running Kanotix hd installed debian style 2.6.6 kernel. I have confirmed the the i2c module is in there but won't load except manually. I had it running fine with the 2.4 kernel after installing i2c but the readme's specifically say that won't work on this kernel. lm sensors install says if you have 2.6 kernel to only run "make user" and make user_install" did that. But i2c isn't loading though I can get it all to work with "modprobe i2c_sensor" Where am I going wrong here?
I did alsa try adding to aliases and modules (and did update-modules) I am not getting anywhere. Advice welcome.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Samsung 16GB 2Rx4 PC4-2133P DDR4-17000 1.2V RDIMM ECC Registered Server Memory
$16.29
Samsung 16GB (2x8GB) DDR4 2400MHz PC4-19200 Desktop RAM Memory M378A1K43CB2-CRC
$19.95
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Corsair Vengeance LPX 32GB PC4-25600 (DDR4-3200) Memory NEVER USED LOOSE STICKS
$40.00
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$13.25
TeamGroup 16GB PC4 2666 PC4 21300 DDR4 2666MHz 1.2V CL19 Desktop RAM Memory
$27.95
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 64GB 4x 16GB 2Rx4 PC4-17000R DDR4 2133MHz ECC REG RDIMM Server Memory RAM
$87.96