Have you tried netcardconfig, from a root shell?
Just did a hard disk install of Knoppix 3.4
The PC on which I did the hard disk install had no CDROM drive.
So I ran Knoppix 3.4 Terminal server on my laptop.
Then I made the PC a client to the Terminal server.
Now the PC is running Knoppix 3.4 off the hard disk.
Because this PC was a (Terminal server) client, the 3c509 network
card module started (as a DHCP client) before the hard disk install.
Now when the PC boots up with Knoppix 3.4 from the hard disk, the
3c509 card is detected but it does not start as a DHCP client.
Now the PC has no network connection.
So the question is -
On this hard disk install, how can I get this 3c509 card
to become a (persistent) DHCP client every time the PC boots up?
Thanks.
Have you tried netcardconfig, from a root shell?
Yes, but netcardconfig did not show me any network cards.
So I looked into /etc/modules-2.6.6
and noticed that 3c509 was missing.
I added 3c509 to /etc/modules-2.6.6
and rebooted. Now the 3c509 module
loads at boot time and since DHCP is
already a boot option the DHCP client
is happening.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$16.50
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$13.50
HP Hynix 64GB (4x16GB) PC3-8500R DDR3 1066 MHz CL7 Server RAM 500207-071
$12.50
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Team T-FORCE VULCAN Z 32GB (2 x 16GB) PC RAM DDR4 3200 (PC4 25600) Memory
$54.99
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$9.99
CORSAIR DOMINATOR TITANIUM 96GB (2 x 48GB) DDR5 6600 (PC5 52800) Desktop Memory
$349.00
USB Flash Drive Memory Stick Pendrive Thumb Drive 4GB, 8GB, 32GB, 64GB 128GB LOT
$249.37